Home Portable Devices > HP-UX ULTRA320 SCSI DRIVER


The system hardware uses slot-specific power control, combined with HP-UX operating system support, to enable these features. B bit A binary digit. An operating system performs basic tasks such as moving data to and from devices and managing information in memory. Confirm AA adapter firmware and update if necessary. Table 3 briefly describes the content of each chapter and appendix. In most cases, target device SCSI IDs are set automatically by the storage enclosure or by a switch on the storage enclosure. Enter the file name for the firmware image, then press Enter.

Uploader: Arashilkis
Date Added: 14 September 2016
File Size: 21.51 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 30731
Price: Free* [*Free Regsitration Required]

You are right with the first disk.

HPUX Sept cannot see PCI-X scsi adapter

To determine the device file names for the channels on the AA adapters that are installed in your system, use the ioscan -fnkd mpt command. This allows programs to operate in parallel. Record all error messages and numbers ulttra320 appear at the user terminal and the system console. See your HP sales representative for details. Alternatively, the mode parameters, microcode, or inquiry data for the device have been changed.

Contact Email us Tell us what you think.

Email to friends Share on Facebook – opens in a new window or tab Share on Twitter – opens in a new window or tab Share on Pinterest – opens in a new window or tab Add to watch list. Confirm AA adapter firmware and update if necessary. One bit in the transfer is used to make the sum of all the 1 bits either odd or even for odd or even parity.


uptra320 The executable file name of the EFI utility is: Add to watch list Remove from watch list. The AA adapter firmware version can only be verified or updated online, using the mptutil command. You are about to install EFI Driver version 1.

A7173A PCI-X Dual Channel Ultra320 SCSI Host Bus Adapter

Usually kept as firmware ROM based. The problem that we have observed is happening on storage 1. To reboot the system, enter this command from the system prompt: All forum topics Previous Topic Next Topic. Make sure you have the correct SCSI ulgra320 configuration.

uptra320 Act like your business depends on them by David Gewirtz. Hewlett-Packard shall not be held liable for errors contained herein or direct, indirect, special, incidental or consequential damages in connection with the furnishing, performance, or use of this material.

This information can be supplied to an HP support engineer if ulttra320 need assistance troubleshooting a problem with the SCSI controller. Auto termination is factory enabled on the AA adapter. See the iostat manpage for more information. Could it be cause of constant reseting the SCSI path that you mentioned earlier?


Learn More – opens in a new window or tab International shipping and import charges paid to Pitney Bowes Inc. For important details about each of the SCSI parameters that can be set online using the mptconfig command, see: There are separate procedures for setting and confirming the SCSI parameters offline and online.

Send the output lutra320 the system failure memory dump to the HP representative. Port Information Use the -P option to displays port information; the data is displayed as a series of hexadecimal words. This state could result if the driver was unable to successfully initialize the channel.

Domain Validation Domain Validation automatically detects, and if necessary, compensates for hardware that is not performing at the optimal level. An exception is for the termination. Robert, thanks alot for your reply, and sorry for my delay in sending reply. Consult with your Hewlett-Packard representative for information on specific system configurations.